Took my batteries out to clean and check water. Made myself a sketch of all the cable and wire hook ups. I forgot to mark down one wire. It is a white wire, it goes up into the harness and changes to 4 wires and then it goes into the top right hand connector of the ecm if you were looking at it head on. I am pretty sure is goes to negative but not sure. Did a bunch of searching online couldn't find anything to make me 100% sure.
Any help would be great
Thanks Mike
ECM Series 60 Question
Discussion in 'Ask An Owner Operator' started by 9200 IH, Jul 5, 2018.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
1996 Detroit Diesel Series 60 370/430 hp
International 9200 -
Picture of it?
-
White tends to be ground (negative) in Freightliners. An ohm meter should confirm that it is grounded to the chassis.
-
Thank you for your reply. My grounds are white too. The stuff I found online showed these 4 wires to be black on a Detroit diagram. I got it running. Everything is good.
Thank you for your help
Mike
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.