1992 international 9400
Speedo and Tach gauges will peg out when truck is started. Tach works properly but speedo does not work. There are two sets of wires coming from the speed sensor so I would assume the speedo reads directly off the sensor?
HeavyD: I hope you read this because you could really help. Back in 2016 there was a thread where you uploaded a wiring diagram to help a guy with this same issue. I couldnt get the wiring diagram to download. Do you still have that? Thanks for the help.
Gauge Problem. Heavyd...please help!
Discussion in 'International Forum' started by bwinters149, Aug 5, 2018.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
@HeavydShock Therapy, Bean Jr. and 4mer trucker Thank this. -
Here it is again.
Attached Files:
SAR Thanks this. -
-
-
I think it is because you are new member. Should work after you get a few more posts.
-
-
-
Hi heavyd I have a 2001 9200i and my oil pressure light is on and i have replaced the oil sensor and plug and cluster panel and it still comes on i have checked with manual gauge by oil filter and it says I've got good oil pressure any ideas
-
That gauge and warning light gets it's data from the engine ECM. I would be plugging into the engine and check for codes and see what the ECM is seeing for oil pressure. The side gauge panel is actually run and controlled by the center speedo/tach panel incase the cluster is faulty.
SAR Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.