2012 Prostar, Maxxforce 13, was losing power and codes were lighting up pointing to the DPF. Truck has just under 450k miles so I decided to install new DPF, DPF Pressure sensor, DPF I/O temp sensors. Removed DOC and preDOC and cleaned and reinstalled. Truck is still limping and these are the new codes.
3223 05
3246. 03
3251. 04
4766. 03
4765 03
I believe some of these codes are referring to sensors I just replaced. Any suggestions would be appreciated.
Maxxforce 13 derated...have codes
Discussion in 'International Forum' started by DirtyDog13, Jun 7, 2019.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Did you reset the ECM when you did the new installation?
-
-
Clear your codes and run the engine to see what comes back.
-
Cleared codes, same result. Went to dealer and it turned out to be the O2 sensor. Which was the one code I didn't do anything about. Was told I needed a "special" tool to remove it so I let the dealer do it for $1000. Back on the road now.
Heavyd Thanks this. -
$1000 for an O2 sensor? And I thought the price was high on a passenger vehicle!
-
Where is the O2 sensor located?
-
2013Maxx Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.