MBN Problems....

I would bet these rings are the result of our guys on roadtrains hammeing the crap out of them at 110+ tonnes..

 

Can you set up a MXS or NXS to run on the 59s?

 

I see you guys are talking about a C16 2300 hh program. What is the advantage of this over the regular C16 program?

Is it just moving up the powerband 200 rpm's?

 

Wider powerband

 

Wider from where to where? I run mine at 1400 to 1500 rpm's. If I have it flashed to the 2300 hh program, do I have to up my rpm's by 200?

And by the way 550hpW900L that dyno vid makes the hair stand up on my arms!!!

 

Thanks lol..... No you dont have to up your rpms 200, it will run just like it does now. What i noticed with mine is that it does not die off past 1700rpm like a 2100 program does, it keep pulling strong till 2000rpm. You will have as much low end as you do now.

 

Thanks, that's what I needed to know. I'm getting my 6nz flashed to a 7cz and just wanted to know the difference in the 2.

Hope when I'm done I can post some respectable hp# and fuel mileage#.

 

Good luck! It has been fun for me and im just enjoying the hell out of this MBN motor, the dyno operator said this is how the MBN should've been built from the factory! I didnt disagree with that.

 

Hey Robnozz, let us know what you get after the flash!