My Schneider Adventure

@T_TRUCKER. ... hey I wanted to bring this up this just came across my mind... I had a similar incident a couple months ago in Mechanicsburg PA Why showed up and the customer said the load was going to be ready for another six or seven hours and I called and told them and I explicitly told Schneider that let me decide what I'm going to do and see if there's anything else and after I looked at the load board and decided I'm going to just keep that load they went ahead and took the load off of me without asking me... I jumped on the phone immediately and raise seven kinds of hell and tell him to put that #### load back on me I was going to keep the load and run it because that's my load to get me back towards the area where I need to go home... They immediately complied and put the load back on it along with everything else behind it that I had... That's what you should have done last night... So if that ever happens again follow that mode and do that that way they don't stick it to you like that ever again

 

@freightwipper .....yes promoting the program by Ur positive comments about Ur earnings
B..ching....U guys do Ur share when Ur fustrated ( with good reason when SNI stupidity costs ya)
And U all stay there cause even with the changes ( economics and contract wise) probably not much better for van freight
Probably not much is going to change til after the election so hope U all can weather the storm

 

I've kept it real with my experiences here both good and bad. Oh and yes you're right, I do my homework and if i could be ballin in money elsewhere I'd leave but no such place exists so here i stay lol.

 

How U making out with the engine repair?

 

Picking it up in two hours then off to Ohio

 

Hopefully it's done right... I would check that thing over with a fine-tooth comb before even leaving their lot and also make sure you get all copies of the paperwork before you leave too

 

Good luck with it
drvrtech77's couldn't be more true

 

@T_TRUCKER. so whatever happened?

Did you ever try to get the load back?