OOS for not having a permit
Discussion in 'Ask An Owner Operator' started by pavrom, Jun 21, 2019.
Page 5 of 10
-
whoopNride, IH Truck Guy, spyder7723 and 4 others Thank this.
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Guess this train done jumped the tracks
wore out, exhausted379, 7-UP and 3 others Thank this. -
You must have missed the thread where he said that he'd move an Oversize RGN load through NYC for $4/Mile...
Or the thread where he says "I'm one of the Eastern European Drivers from Illinois that's taking all the freight" and he even puts a LOL after he said it....
It's not that hard to figure out adaryder...
Did you miss the mailbox numbers on his truck?
Must be hauling expensive freight on that stepdeck...whoopNride, D.Tibbitt, exhausted379 and 5 others Thank this. -
7-UP, snowman_w900, johndeere4020 and 1 other person Thank this.
-
Hope you didn’t have big plans for that $22 you saved. What other state did you cheat in.
D.Tibbitt, Oxbow, rollin coal and 3 others Thank this. -
If you have loads lined up for yrself at $5 both way - i wish i could do it but thats not my case
...dont remember saying taking allcheap loads ( i guess yr meaning ) ...
Explained mailbox numbers
Its very subjective whats expensive for me - could me cheap for you , i am glad that you are very successful , pls share your experience so everyone can become -
You could say that permit must be ordered before ( thats what i did when i moved 12feet this week ) ...this time i was assigned this load last minute and sometimes it says overdimension but its not ...
I dont think its proper to call someone cheap without knowing lot of details about particular person -
How can you be sure without knowing me ...i probably run til 9:30-10pm ... It was my load home , i had enough time to deliver it today
If i run 10 oversizes a month and dont get permits for 5 of them - thats $1000 extra in my pocket , considering average 5 states per load ... Call me cheap - im fine with that .
As i mentioned if the load barely over - i would run it without and doesnt make me less safe than someone with permits -
bryan21384 Thanks this.
-
What you've just said is no excuse for not having a permit.
"Hey customer, yeah I got the $750,000 CNC Laser soaked with water and debris, but I was in a hurry so I couldn't really do a very good job tarping it......" same concept
Yeah, I'm sure that goes over wellLast edited: Jun 21, 2019
whoopNride, D.Tibbitt, 7-UP and 8 others Thank this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 5 of 10