This is my personal toy..NOT cuttin any holes anywhere....Gotta figure out a cb mount and how to run coax before i do ANYTHING to it..
Photos
Discussion in 'CB Radio Forum' started by stacks, May 29, 2016.
Page 3 of 5
-
Attached Files:
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Hard to beat a truck of that Era the modern trucks now are junk c-13 cat what vhp do you get with that engine
-
You guys are lucky in North America you have large vechiles with plenty of room to mount radiosrabbiporkchop Thanks this.
-
-
336 crap thats low....Must hate the hills with that..355's 13 spd on low pro will do nicely but being an over drive trans makes it less efficient and steals a wee bit of hp/tq to the ground so i can only imagine 336's..
Ougigoug Thanks this. -
My console Is 10 inches wide.
Here is a smaller one at 8 inches wide.
-
The thing was open my run was Mtl-DFW weekly basis no big hills.
I did maybe 50 west coast trips with this and honestly i can't complain that little Cat was doing the job and i was maintaining a nice avg mpg considering the fact that the truck was racking up serious miles on a weekly basis. -
The TS50S is a nice radio for sure, had lot's of fun with it awesome on SSB plus possibilities to listen to radio station around the world.
-
Here is a picture of a Havis console made for a Ford Escape.
Ougigoug Thanks this. -
Now that is profesionnal looking console!rabbiporkchop Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 3 of 5
