Post flatbed load photos here V2.0

See if this helps. It’s my setup. On 295/75R22.5

 

4 loads today
one @ 64’
3 @ 63’

 

even at 47.5” with 10” of neck from the pin plate to the deck, you could only put 104.5” on the deck for 13’6 overall ( i realize you likely can be 14’ overall but this side of the river 13.5’ is it for legal height.

 

There’s a couple of R/R overpasses that I’ve been thru that post 13’5”, I’ve had loads at 13’6 I never kiss it. I think they post low and give you 2 inches or so to spare. But I’ve dumped the airbags and creep thru them slowly.

 

i leave that particular place in brooklyn
And see the folllowing:






And there’s 3 of them: and I know the third one is under 13’ actual clearance as my antennae used to bounce off the cross members




I was definitely short on patience when I posted that this morning. Somehow at 5am theres always some dick head with #### to talk about something.

 

Only 1 I got this week. I don’t tarp often, but when I do I waste as much time as possible so they don’t ask me to do it again.

 

Bridge frames…

 

The groundhog lies!

 

No stack boot?

 

No Deere says their turbo’s aren’t impacted, if it were a CAT I’d cover it…