Post flatbed load photos here V2.0

2 full units of plywood.
6 half units of plywood.
1 pallet of cedar perfections.
2 units of 24' 2x10.
1 unit 22' 2x12.
5400+ lineal feet of 1x8 ship lap pine.

 

@Ruthless You had room for a couple kegs of nails on there too; quit slackin'!!

 

Something different.

 

Some more of those UGLY van freight loads on my skate...

 

My first load of skidded coils.

 

I normally wouldn't post a picture so out-of-focus, but this was a new one for me, so I cleaned it up the best I could:


Each concrete septic tank is about 15,000 pounds. Axles were balanced almost perfectly (36,500 on pup, 34,500 on tractor drives and 45,000 on bridge). Gross came in around 130,000 if I remember correctly. Was running this up to a place called Little Saskatchewan, MB. Right near Gypsumville if anyone might be familiar.

Not sure if anyone will notice, but I'm running a new truck. My inframe has turned into a complete rebuild (they found some stuff on the block that needed more serious attention) so I'll be in this thing for a while. 2007 379, NXS C-15 TT, Eaton 18. Sticker on the side says 455HP, it pulls like it has around 500HP. Turbos push up to 40-42 psi under full load.

It's not MY truck but it will do for the interim.

 

Ummm driver. . . You forgot to tarp it. Can't have those trailers getting dirty now.

 

Easy money. Now don't be shy, let's see that securement.

 

I just used 200 extra tarp straps when I tarped. The straps kept cutting when I tightened them

Yesterday's load of self drilling rod. I didn't load it, hence the straps. I pushed the bundles tight, added one choke chain per row, then added one chain per row.