Post flatbed load photos here V2.0

A problem I didn't notice.

 

Waukesha Engine. It's a V12 Natural Gas engine. Generally used to run generators. No tarps. I do need to throw a small tarp over that little cardboard box before I leave.

No demotion. I jump around all the time.

 

Is that a strap in the center?

 

There were several on the trailer, used as chain extensions, but still not the specific problem. Keep guessing!

It might not be obvious from the picture. I didn't notice it at first.

 

I see what looks like a loose piece from the red car on top at the back. Also most of those loads usually require a mesh tarp over them to keep loose pieces in every time I've seen scrap loads like that.

 

Nope.

For those that can't figure it out:

Spoiler

It was 15'3" tall.

But I never said that...

 

I agree about that loose piece on top at the rear, the middle stack seems to be leaning toward the Drivers side...maybe just the picture?

 

Just go faster. The extra downforce will make it lower for bridges. At least that's how I think it works.

 

Oh, I checked everything down to traffic light clearance heights with the city. Had the heart skip a few beats under the one underpass even though I knew I was good.

 

Gee, I was going to say the problem is the load is ugly.