Rocker Switch Lights

OK here is the solution,It took me a while but i figured it out,especially after i took the switch apart and i was like oH NO, but being a good repair guy, i got it back together. so there are two ways to do this. the first is ,taking the cover of the front of the switch,the toggle part. you can pop it of carefully with a small regular screw driver.in the center on the side of the switch you will see the opening to carefully pry the cap off,it snaps back on when your done. and you will see the bulbs,in there not a lot to grab at ours is a 06 387 pete NON LED light. other guys were talking a needle nose with vacuum line on it yes cuz you cant grab it alone with the needle nose.
OPTION 2,i will go this route since i know how to do it, on the ends of the switch you will see two white tabs on each end,those hold the base togather. if you take that same small driver and shove it in the end by the plug prongs, you can get it to open , this will fall apart on you,you will see the contact slides,in it and you will see the round part on the slid that make the contact in the switch ,you just make sure it is in the right way, when you put it back together,the bulb housing is in the black part of switch and you can easily pull it out with a needle nose, and THEN you can grasp the bulb with your finder and easily pull them out with out braking them.if you run in to trouble and cant get it together , settle down and sit down AN TAKE A BREAK AND THEN LOOK AT IT VERY VERY VERY CAREFULLY AND REVERSE ENGINEER THAT BABY and you should get it.it is easy I think it is faster pulling the cap off but if you break the build your going to have to take switch apart anyway. just go careful not the break the plastic housing.now to find bulbs LOL thats why i was searching google

 

I found online the bulbs, there also manufactured By Eaton
http://www.newark.com/eaton/28-5901/switch-component-lamp/dp/29C6285

 

Also if your laid over for the weekend in MN around the Minneapolis /st. paul/ Northfield,area truck stops, i can do this for you,if you cant do it your self I also do other repairs too.