SPN 521 FMI 2

Discussion in 'International Forum' started by Audreyng2001, Jun 8, 2020.

  1. Audreyng2001

    Audreyng2001 Bobtail Member

    13
    2
    Mar 29, 2015
    0
    I have a 2015 International Prostar with a ISX and an autoshifter trans. It also has a wingman collision mitigation system, I say all the above because I have been unable to resolve the above code. The engine light comes on when the Brake pedal is depressed and then released whether the park brakes are set or not. I have checked all the wiring, connectors, bulkheads, rebuilt the taillights and wiring and replaced the brake light switch. The trouble shooting guide states the pedal position switch is the fault. If there is a second switch could some one tell me where it is located.
    Thank you in advance for all your help and advise.
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. jinxutoo

    jinxutoo Light Load Member

    90
    128
    Jan 17, 2012
    Illinois
    0
    Behind the kick panel above the brake pedal there is a switch connected to an airline. Can't remember the name of the switch. Mine was doing the same thing until I changed it out. Around $60.00 I think.
    Brake pressure switch.
     
  4. Audreyng2001

    Audreyng2001 Bobtail Member

    13
    2
    Mar 29, 2015
    0
    Thanks will check that out.
     
  5. Audreyng2001

    Audreyng2001 Bobtail Member

    13
    2
    Mar 29, 2015
    0
    Is Heavyd around and how do I get his attention for this issue.
     
  6. Heavyd

    Heavyd Road Train Member

    6,956
    4,955
    Feb 4, 2009
    0
    QUALITYTRUCK Thanks this.
  7. Audreyng2001

    Audreyng2001 Bobtail Member

    13
    2
    Mar 29, 2015
    0
    It is not the switch purchased it from the international dealer via the vin. Have checked the wires and connectors even changed the pressure sensor which made it worse.
     
  8. Audreyng2001

    Audreyng2001 Bobtail Member

    13
    2
    Mar 29, 2015
    0
    Heavyd do you know how to calibrate the brake sensors?? I was told when installing the new sensor one must do a series of thing ie; step on brake and release park brake with key on or something like that. Any truth to that??
    Any guidance would be helpful.
     
  9. Heavyd

    Heavyd Road Train Member

    6,956
    4,955
    Feb 4, 2009
    0
    There is no calibration.
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  • Draft saved Draft deleted