I have a recently purchased 2019 Peterbilt 389. I bought the lights to go under the cab and under the sleeper. Could some one tell me if the truck would be pre wired for these lights?
The last six of the VIN are 629108.
If it is not pre wired, how and where to I connect these lights?
My thanks in advance.
Phillip
Under cab and sleeper lights question.
Discussion in 'Peterbilt Forum' started by Auctioneer, Jan 31, 2019.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Those are not pre-wired as far as I know, I had mine wired into the headlight switch.
Auctioneer Thanks this. -
-
Looks like it should be wired from factory. Should have an aux light switch on the RH side of the dash. Wiring leads should be tied up behind air cleaners and under the hood tied up by pass through for the air inlet piping. Diagram attached. If I remember at work tomorrow I'll grab a pic.
Attached Files:
Auctioneer and spsauerland Thank this. -
-
Thanks for the information.
I was able to locate the woring for the sleeper and cab lights. There is a connector for both RH and LH lights. They were in a bundle on the firewall just below the windshield and to the right of the windshield wiper motor.
Got it all hooked up and working well.
Thanks Again.WyoVac, spsauerland and pushbroom Thank this. -
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.