What if it Snows?

Pic 3. Clean up flywheel magnets and coil bracket with fine emery cloth, then reset gap with any non embossed business card, (Farm boys 30 thousandths.)
Pic 4. Remove tank, empty. Drop in 3 or 4 solid small rocks (or teeny balls from b/bearing), add 1/3 amount of gas and shake/contort, tap edges against some solid subface) loosens rust and other crud, rinse out with gas twice....
Pic 5. Discard sponge filter. wash out with gas, oil new with 30W, well squeezed.
Pic 6. Check number on plug, look up proper plug, obtain proper plug, set gap on 30 ths, toss old plug.
(Lay over on one side. Stick a screwdriver in plug hole, hand turn with blade to bottom piston, spray a few shots of WD40 in to lube the rings coming up.)

More to do: Change oil, sharpen and balance blade.

(Line up a kid in neighborhood to use when running,)

 

Be sure...

 

Born service writer here...

 

These don't clog up in wet grass,

 

We've stopped to cook a SALISBURY STEAK.

Otw here we somehow missed our third (3rd) head on collision since we've been with Landstarve.

This one was with empty skateboard Cascadia.

What's moar impressive is we're 78K and somehow didn't roll III.

The OM was not pleased.

 

Back then the architect said "hey we are on a budget, make the dock 13'7 and not an inch higher.


12 down, two left to deliver then it's lunch time. Happy Monday to everyone on WIIS.

 

Tite Fight, but U 1

 

Sounds a little hi, but then again, what caliber pistol you using?