That's how mine is. The guy I got it from used the center pin for his dump axle. The abs on my triple axle is always throwing a code. With two axles in the air and sensors on four wheels it doesn't like it. I just leave it off anymore and let it run off the brake light.
Where is everyone #5
Discussion in 'Flatbed Trucking Forum' started by DDlighttruck, Aug 27, 2017.
Page 12555 of 22055
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Just set the knobs in Napavine, Washington.... I’m gonna need a few adult beverages after today and before the #### show that tomorrow could possibly be. On the bright side I’ve been told traffic will much lighter than usual, which is very cool!
PoleCrusher, Eldiablo, cke and 6 others Thank this. -
-
Everything up here is still open, so far anyway. Kinda odd since it’s the epic center for the virus stateside... but hey, Ohio is shutting down all restaurants apparently?
rda2580, PoleCrusher, Eldiablo and 6 others Thank this.
-
Brackets were just about wore through. I welded them back up and turned them around the other way. Now I can open the hood again with one finger. It’s stays in the center of travel all by its self again.
Got my oil change done, grease job, fixed one of the grill bolts, boot box latches, temp repair on one of the 1/2 fender brackets and remounted the mudflap. The fuel filters I ordered were wrong so I’ll have to do that tomorrow. I’ll head over in the morning and see if I can find an ac compressor. I already have a new set of belts on the shelf. Got nothing lined up so I’ll work on it till something comes up to load.
TripleSix, PoleCrusher, Eldiablo and 10 others Thank this. -
-
PoleCrusher, cke, singlescrewshaker and 3 others Thank this. -
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 12555 of 22055