Thought I felt er squirm a bit while naw'n.? Lol
Shoot it gets better. Just realized she didn't charge me for them 3 Miller's.!![]()
Where is everyone #5
Discussion in 'Flatbed Trucking Forum' started by DDlighttruck, Aug 27, 2017.
Page 19879 of 21403
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Was gonna get baked tater, but asked her opinion. Pointed me at the shrooms. Can't complain, gotta live on the edge now & then..cke, CAXPT, exhausted379 and 7 others Thank this. -
Pretty good idea…
-
Pull the corner bits and gain about 8 inches width It takes 5 or 10 min with luck and can save a pilot car rate.15 years ago corner bit bolts cost about 5 bucks per side and I carried 3 sizes just in case. -
-
Just Follow an Emty Coal Truck...They will tell the Loaded Trucks where your at ..
-
Oh.wait...You Live I Coal Country...That's advice for Flatlanders ...lol
-
Back home as of an hour ago. I go though here quite often with O/S loads. Hate that for him….
-
That’s a real sharp curve, there is a small drop off between the asphalt and the guardrail. If you don’t swing wide the trailer tandems end up locked in the drop off….
I pull O/S through there all the time. Only about 5 miles from my home….
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 19879 of 21403