Where is everyone #5

Normally I agree, but......remember the cable tach drive? That square shaft that fit into the head on the tach? Used to put graphite powder in the cable housing but the receptacle on the back would wear and the needle would start to jump.

 

Never heard of them till you posted this, so I did a little reading. Pretty interesting. Seems nobody has anything bad to say about em.

 

@ShooterK2 wanted a picture every day but since I’m sitting in the recliner I can’t take one. A former member is hauling an 880 Grove so I dug into the archive.

 

Good Saturday morning all

 

Hey I didn’t say it had to be current. Lol.

The one I just posted is from 2015. Sunrise over the Arkansas River as viewed from the sand plant at Bixby, OK.

 

What’s one of them weigh, JD?

 

Auburndale. Bout to begin peddling back toward the mountains. Enjoy your weekend gentlemen.

 

About 110,000.

 

Their the large group the continually buys smaller companies... they own SPD/Lonestar/Steelman, etc. Pretty sure they just recently purchased TSH and BTC.

 

Satturday Jonesboro load has to be there by 10 am. So I get there At 6:55 am, security says receiving didn't come in today and she can't let me in. Of course not, we only bring up to two loads daily since 2013.

They show up and say "hey we need to finish unloading door 36 and have you pull it, spot yours. Our spotter is off weekends. These guys are always cool, get me in and out, so I say hey no problem. Tell Bossman I need my extra money for the inconvenience, get my 30 minute break (ahem) and head back south looking for the weekend.