Where is everyone #5

Believe it or not, that is the one tool I have never lost.

 

I haven’t either but I hear lots about it. A 9/16 however is kinda another story for me

 

I have a few that grew legs.

Worst part is that NAPA changed their tool lineup and you can't order replacements. The new ones look different and are three times the price. Been looking for these for a month and I'm still mad about it. I might block out and find a pawn shop in the city that has what I need.

 

No never seen it, pretty neat can openers though….

 

5/16" and 7/16" here. Never fails, I'm always huntin those, or 8's and 11's.

Dahm clamps

 

I figured you might have ran into a couple of them through relatives in the past. When I was a kid, we had two types, the one that your clamp on the edge and twist the handle to turn the little gear wheel and forced the little cutting edge through the top edge of the can.

The other type was the one that you punched through the top of the can and worked your way around the top of the can cutting it open.

Now, they have pull tabs. I remember using engine oil cans for motor oil, beating cloth diapers over the toilet rim…and those 50 ounce green bottle Cokes. The bottles were worth money.

 

I found someone's 10mm 1/4 drive deep well. It was in the wife's rear tire on her pickup truck. At least it was a snap on.

 

Didn’t know that about Napa….

 

That was worth the flat…..sorta almost not really

 

Borrowed my friends new Mac flatbed few years ago, ended up with a 10 mm wrench in the outside dual of his trailer. Never seen a wrench go in a tire like that. Did pull a push rod out of a tire one time…