Where is everyone #5

I didn't realize how messy that end of the shop was until I saw it on video. I need to fire my cleaning crew.

Here's the first video. I didn't edit it. The other 2 are coming shortly.

 

Here's the second and third ones.

 

Awesome! I thought some heat would of been needed to complete that, so I learned something new today. I have never seen that done before. Thanks for sharing!!

 

That right there is a artist....fascinating....

 

@1951 ford , you do awsome work. Thanks for sharing that.

I got a question about your welding/vise table there. Did you build it and is it bolted to the floor?

 

Making a little air and heat Greenville TX. No way I will ever pull a rabbit outta my hat to make Texarkana roll the doors run to Ashdown load at a feed mill to go to Greenwood Ar unload. Hit Russellville reload and be at the hog farm in Henry Tennessee Friday morning. I am leery of these short hops but they got too much candy and I want some of it

 

10-4 on them HARIBO gummy bears, c'mon....

 

It's not bad, with a long enough pipe wrench. I did some 5/8" pieces for a hand rail that required a 4' pipe on a 24" wrench. I didn't have a 36" wrench at the time.

Thank You. It's really kind of fun.

Yes, I built it. No, I didn't bolt it down. It has tabs on the bottom of the legs for bolts, just never did it. I'll get some pictures/measurements if you want.

 

Y'all be cool need to be in Iowa most ricky tick. Be a whole lot easier keep a left lane clear. Flatbed on the move stay right we gone

 

I hope you can run faster than 63 mph?

Lol just kidding! Not really!