no. sitting at the rest are on I70. then in the morning I guess the fun starts.
How bad is the turn in Jewett? on hwy 9. did you go that way?
Where is everyone?
Discussion in 'Flatbed Trucking Forum' started by Cluck Cluck, Jun 30, 2012.
- Thread Status:
- Not open for further replies.
Page 182 of 997
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
In 190k this is the first thing to shut me down since march 11DEMO Thanks this.
-
Conaco off of 135, it is not a truck stop just a flea bag hole in the wall. But hey it is open and has a bathroom, just using my load gloves to touch anything tho.

The holes in the lot are huge brother, I mean measured by the foot.DEMO Thanks this. -
I took hwy 9, it wasent bad. Not very traveled. They have two flaggers at the turn to the rig to hold traffic for you. They will call you on CH 19 as you approach. After you make the turn on the access road, the rig is on CH 24.
The turn off Hwy 9 to the rig is STEEP. I had to jack my trailer up 4 notches so I didn't bottom out. After I bottomed out
Logan76 Thanks this. -
ok, that's not bad then
-
Ok, Thanks for the heads up. All I can do is over ride the air on trl.
Us poor folks do not have them fancy hdy. necks. HaHaDEMO Thanks this. -
get a ld. going home then?
Looking on the boards, kinda slowDEMO Thanks this. -
As long as this isnt a signDEMO Thanks this.
-
Lol, you will probably get half way up the access road hump before you bottom out. You will be well off the road by that time. If you can't clear it call the flaggers. They will call the rig, they have a Cat 950 loader equipped and ready to pull trucks up. Apparently they have had problems already....
On a good note, they unloaded me in about 15 min. I didn't even have to take my chains off, they had 5 hands do it for me... -
Nothing going home, 70k going to TN. Trying to get home... Doesn't look good..
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 182 of 997
- Thread Status:
- Not open for further replies.