Where is everyone #5

Muscle memory 1000%. I've got more more time laying prone with a bolt gun in a dark room just practicing trigger control than actual shots fired.

 

Ok next question. How do i get the top bolt out? I couldn't get anything on it its so tight. TIA

 

I sitck a mid length 15mm wrench in from the pass side. Pull down hard. Use a pry bar to a heat sheild bolt head if necc. Wind em out with a stubby 15mm ratcheting wrench.
Take the crossmember out 1st and lower the tcase tail housing on the torsion bar x member to give more room.

 

Neither am I! All this new fancy junk and power and no burnouts? My 05 5.3l 4l60E 3.73 limited slip will ignite a set of tires!

Said it before, I'm done with modern pickups.

 

Thanks!!!

 

I push and hold mine first thing after starting and the screen says "traction control off" and "advance trac" off.
I can then leave some decent black marks on closed courses...

 

Day one in the books, neighbor asked me what I was going to name my new highway..




Going to finish up the back area tomorrow.

 

there’s a ride

 

Not much happening the beginning of this week. Got one round booked for big red. Usual Jersey city with a reload coming right back to Binghamton.

Oil change and grease on the 93 and need some ducting for the bunk heat to work again

 

Mine says the same thing but I can't even get the thing to go sideways on ice. I read up on it a bit and it sounds like the roll control always stays on. Sucks.