mercer transportation

Forget that last question...just read that it's a DOT requirement. DUH!

 

Try go into the menu and change the device selector. Sometimes, I still have to close the program and restart it again after plugging into the scanner.

 

off the wall but an easy answer, NO. that stuff don't cut uit , along with paint pelled on fairings and such

 

dang its kind of dead in Shreveport.

 

Pulled into the Ontario TA this morning after getting unloaded and even though it was only 10am, it was packed! Haven't seen any mercer drivers but I'm sure they're are some here.

 

Skateboard, did you make it out of Shreveport yet?

 

nope still sitting here, you coming by ? if so as you come to fuel islands I am to right of the scales 3 trucks down

 

Will be rolling through there late tomorrow. If you're still sitting, let's go get a steak.

 

heck, if I am still here tomorrow , steak sounds real good. as I will have had a cow by then.

 

well rolling toward Gulfport,ms for thurs, then reload there Friday for wash,dc then 100 mile dh to Leola,pa to load to Covington ,ky. then dh to Louisville for my 6 monthe inspection, yee haa loads of fun.