mercer transportation

So it seems to be a little more wiggle room on van side for rates. I like getting my deadhead paid on the van side lol.

 

Couldn't agree more.


Anyone got a tip on getting my tandoms to slide easier? Pins release fine but almost seems like I'm blow these airbags on the trailer. It lifts the trailer end really high when sliding.

 

If you have released the pins, make sure all pins went in, if not pull forward or reverse gently to get them to release then slide the direction you want....sometimes when u first push the button a pin or two will be bound up against the rail because of the tension. Once you get them to release they should slide easily especially on these newer trailers.

 

Who you pulling for I mean what agency's

 

Good .luck with them ,when your empty slide it both ways several times to get the rust and road grime out of the slider

 

Newb question. Any recommendations on where to get my dump valve setup/switch installed? Got a 17 Great Dane

 

Pins are fully in. Must be rust or something

Think its sfa? The ppl there are nice

Thinking rust or something also.

 

Do it yourself it's a simple install. Takes an hour or pay around $300 to a shop lol

 

That's the Minnesota agency yes they are nice people ,I run on a dedicated account for them

 

Oh? Is it a decent account lol? I want a dedicated run I did one for ccc last year. I stayed out 3 months made decent money lol