Where is everyone #5

Loooooong time no see!

 

@spyder7723 just left the building - bunch of new lights and all greased up. And full of lasagna.

 

Well sob, I go play local trucker last week which got me home every night and all the drama happens on here lol.

@sawmill You said you felt like you mightve been spyed on in Childress. I doubt it was me, cause I'm a talkative mf'er.

Blair, good call on the bs.

 

@CAXPT

There is only 1 guy that has a co. in Rogers, Tx. He's been there a long time, runs flatbed and stepdeck last I knew. I went past his place Thurs afternoon leaving a pick up. Is that who y'all think TX2Day was pretending to be?

 

You make that kiwi kids lasagna?

 

The adult version smarty pants.

 

Actually, that picture you posted is pretty good.

 

Ya it's been a day or two. Hope all is well in your world.

 

Ya the sun was at the perfect angle for photos. Made this old freightshaker look #### good.

 

Oh and F Rush Peterbilt. My 2 week old air dryer blew the safety cut off valve out of it, while the truck was off. I reinstalled it and ran the rest of the day. That evening, it did it again as I was going down the road. Barely made it to a Cefco in Godley, Tx and spent 2hrs trying to hackf### a plug to get me down the road, no luck so I went to bed.

Fri morning I start calling for the part, which apparently no one had. Then the guy goes "why don't you just bypass the dryer to get you down the road". I didn't have an answer except for that I was so focused on a temp fix of plugging it, I didnt even think of bypassing it.

That lead me to trying to find the cutoff valve kit and apparently not 1 place (Rush, MHC KW, Fleetpride) have the kit or even an AD-SP air dryer in stock. This also led me to find out that the warranty on the Rig Tough version of my dryer is basically bs. I would have to remove the dryer, give it to Rush along with some warranty claim paperwork and wait for them to send it off and test it. Obviously that didnt happen because I wasnt going to sit in Waco for days on end like a fool.

Luckily I kept my old air dryer and with a couple new orings and a new snap ring, Im back in business. So I guessing the original snap ring was defective and decided it wasnt going to hold back 120psi.