Post flatbed load photos here V2.0

Off to Waller Texas

 

@D.Tibbitt this one is for you.

 

Hell yeah !! Nice brother !!!!

 

Lol, yep!

 

Snagged this cutting disc rotor out of Bettendorf, IA this morning going to Vallejo, CA. This goes in the bottom of one of those machines at a metal recycler or scrap yard that you can drop a car or refrigerator in and it shreds it to pieces.

 

This stuff is sketch as hell.. Dont think i could throw enough securement on this ... those silver pieces are walking all over the place no matter how much i tighten them down.. Already had to bang in the little 2x4 dunnage they put underneath the gray pieces .. They walked out on me as well.. Had to cut a couple off because i couldnt pound them in...the silver pieces are banded together in bundles of 3 side by side but each bundle is turned and moving different directions... any suggestions ?? I am out of winches on my trailer but have a couple 2 inch ratchet straps left..

 

Try running the straps over the top of the gray bundles to apply more down force or use hand ratchets and strap the 3 gray bundles together.

 

Thank u . The reason i didnt go over the top is because i didnt want to bend the pieces. Only exception is the one on the back over the top was only way to secure them.. And i put 2 straps over them , not very tight and it is about as tight it could be without bending the metal