Newly converted 9spd to 13spd issues

Hey folks I’ve got a new to me Peterbilt with a MX13 that was a fleet truck I’m sure that had a 9 speed eaton. They converted the trans to a 13 spd and without splitting gears it works fine. Upshifting from the high split to the next low gear rpm’s drop ridiculously fast and I’m finding I have to feather the throttle a lot more than I remember to keep it from grinding. 5h to 6l- grind and so on. I really don’t think it’s my habits that are doing it but what do you guys think? Is there some sort of programming that needs to be done along with the conversion in the exam or something? A setting that is off that I should look at? Any info would be great, thanks. And fwiw downshifting is no issue. Also no grind from low range to high range. And just a slight “clunk” when splitting to high side in each gear (off throttle and back on again)

 

Nope. I preselect both the range and all splits. I haven’t noticed any strange noises from the lines but did work through the gears sitting still and it seemed the splitter was inconsistent and weak. Almost like it wasn’t actuating the gear fully. Not sure if that’s an issue. I’ve got a few decades under my belt shifting these and this one something is going on- just trying to save a buck or two here and there. Thanks for replying!

 

Great point guys thanks

 

I'm going to do try that today. Appreciate everyones replies. Will follow up this evening

 

I get what you're saying but then that raises the question why the manufacturer would even install that setup knowing full well the upgrade would be done eventually. Although, there is plenty of other things they do that just don't make sense either!