RGN fenders.

Mine are open. I think @ElmerFudpucker built some for one axle on his old trailer. He might have made them detachable on one end - I can't remember. He should be along at some point.

 

I built them for the new trailer too. I can completely remove them if I want. 1/4” pvc sheet cut in half. Then ripped down the middle.

 

I used 3” channel as a riser / spacer then covered it with 3/8” plate. Needed the ability to haul a mini excavator with no issues of it contacting the tires. But has since been very helpful in hauling other equipment….

 

I ran out of fender washers

 

Middle picture looks a little wonky but it’s just the angle

 

One thing about the pvc is that it will crack if you don’t pull the pin out of one side and let it lay on the tire. Especially in cold weather

 

And it’s ABS plastic not pvc. Sorry

 

It’s like 100 bucks for a 4x8 sheet. That will give you 4 fenders. I found my at a local plastics dealer in town.