Adding Lift Axle Cost

It's all manual. I have 3 different options. My drive airbags.
1. Lift the valve up
2. Raise the airbags on the trailer. I have 4 height levels there.
3) Worst case but will take longer is: drop the trailer and change the collar, donut, plates to higher height. I have only 2 options there.

I tried using the lower level on the collar and that was a mess. The way my ramps are (2 inches lower than the deck/well), they were dragging dirt everywhere on dips/potholes. My guess is that I don't have the right truck because my fifth wheel is only 43 inches from the ground.

I am brand new, so please take this with a grain of salt. If I am mistaken in anyway, please everyone let me know!

 

Thank you! I looked into it just now, and I will definitely get this done sooner rather than later.

 

Broker is Trinity. Rate is about what your saying. Broker is paying for permits. Would greatly appreciate advice on pricing. I asked my dispatch if this was the best we could get, and he said for same day load it was. He said all good loads in RGN are booked out weeks in advance due to permits. Also, I am very happy with this load. Gave me a practice run with the RGN. A little nervous with over width loads in construction zones. In my flatbed the over width loads are much easier to do, because my deck height was higher than the barriers and cones.

 

I thought the same thing about why needing an RGN for this load. Personally I don’t see anything wrong with this load. Looking for some constructive feedback on rates.