Funny Whinning Noise!!!

Now thats funny right there!

Got the rears bolted up, front pig back in, my old hubs and the axles are in. Tomorrow will measure for the driveshaft after I get brakes and some wheels on her.

 

Thanks!

Not counting the time to take out the driveshaft, maybe an hour, if that.

 

Well I guess I should've been more specific. My SQHD PD was simple. After you get teh yoke off you just turn i tupside down, knock off the case, take out a few bolts and its in pieces.<<< short version.

In the Rockwells I have now its a little more work from what I've seen. There is a bearing on the back of the shaft that you have to take off, IIRC. If you have trouble with that it would take alittle longer. But once you get it off it won't take long from there. IF you have to change the fork it will also take a few more minutes.

I'm no expert so take all this witha grain of salt. I'm sure someone on here will know better so maybe they will explain it.

I wish I would've taken pics of the power divider when I took it out. Most people don't understand what it is. If I remember tomorrow I'll take a pic of the one I have laying around.

 

To answer you replace question... If you didn't need to change the race in the housing, it would probably take you longer to get the driveshaft out then to take out the PD and put a new one in.

 

Josh, I think it was you who asked about the powerdivider? Heres a cpl pics of the new one.....

 

Finally done!

Such a beautiful site!