i have read alot about the fuel wire and boost wire mod but i havent found anything telling you how to do it, can anyone give me a step by step on how to do it?
p.s. this is on an 05 c13 in a 378 pete
05 c13 fuel wire/ boost wire
Discussion in 'Trucks [ Eighteen Wheelers ]' started by james3505, Jun 27, 2011.
Page 1 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
anyone?????????
-
Try here...This thread Is very Informative
http://www.thetruckersreport.com/tr...wheelers/34703-caterpillar-power-harness.html
I Did a C-15 and they have a 2 wire fuel temp and a 3 wire boost....If your C-13 has them i could tell ya. -
thank you, i do have the 2 wire fuel and 3 wire boost any help would be a help -
I'm interested as well. I went to the other thread but after 17 pages of guys talking about everything except a diy for the mod I decided to come here and hope for an answer. Thanks
-
i am mostly looking to find out what size resistor i need and wich wire do i put it on
southtx Thanks this. -
I used a 100 ohm In fuel temp line....that's ok for there and the boost Is 1000 to 1.5k..... I use 1.5k and It's in the green wire on the boost sensor.I made a harness so I did not have to cut the wire and can be put back easily...good luck
KB3MMX Thanks this. -
thank you for the responce, i will get some resistors and try it out
-
i bought a set from diesel freaks in michigan,i have a 05 kcb,c-13 it did wake it up,boost wire gives you a lot of black smoke,unless you roll into throttle kind of easy.
KB3MMX Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 2