Bulk Workflow question

If you have the volume turned up on the Qualcomm Jill will tell you "a new preassignment has been received".

 

Well you did ask how you were supposed to know. Thats how you know.

 

That's really the only way as far as I know. The orange exclamation point circle will almost ALWAYS be on. Even a simple workflow update will trigger it.

 

1. Not to be a smart ### but the way to know if you have a preassignment is to check workflow when you are stopped. No other way

2. MAC 16 is gone (most likely). Van's MAC 14 or 17 (whatever the one for schneider directions) is gone for us. The question really is how accurate do they input the GEO codes into Navigo to show where the place is located. It's usually 100% accurate on van side (actual location on the map is accurate, directions still can be goofy). I know when I ran bulk a lot of the chemical plants are a pain in the ### to find (addresses not marked, 100 different plants in the same area that aren't marked, etc). Good luck with that lol

 

I have my Samsung in a cradle with the SNI app opened; a fingers hits refresh every 8 minutes when it's not occupied hunting my nares..
Usually only do that when I am near my drop because my pre-assignments don't hit me as early as they use to.

I write the last few directions on my wing window with an eraseable marker but I run 95% of my nav off my Garmin only cross referencing Navigo for the last few access directions

 

I just check my not and press assignment every time I stop. O TN error than that I don't worry about it.

In theory the old SNI directions got put into navigo. In practice y'all will spend the next year sending feedback to update the navigo directions.

Welcome to the dark side by the way.

 

Hope you have better support for SNIfus when you call in. (See what I did there?)