When you cross that invisible boundary marked by an itsy bitsy 'Welcome' sign from NY into VT and it isn't STAA approved...... I think VT has stake in the game at that point.
I wish you luck in the endeavor tho, bud.
Person I am, so long as it doesn't kill you, I also hope I get to chuckle at a bit of misfortune. Lol.
Edit: I don't think you understand just how much Vermont hates truck traffic.......
Who has their Rand McNally handy?
Discussion in 'Experienced Truckers' Advice' started by rank, Feb 28, 2018.
Page 2 of 3
-
HalpinUout, Shock Therapy and rank Thank this.
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
That atlas is available at any truck stop.
Why don't you buy one and actually look for yourself?
Or, you could just go in and look at it. No one will stop you from checking out the atlas. -
I'll bet it'll be closer to 13-7 than 12-7 because NY used to allow an extra foot for snow build up in the winter.At least that's the way it was back in the day! I've been retired 11 years and haven't done NY in over 18 years.
-
I have one, of course LMAO. That's how I knew there was a low clearance to begin with. I just didn't want to walk out to the truck to get it. That's where my bud @HalpinUout stepped in.Feedman, KillingTime, HalpinUout and 1 other person Thank this.
-
That's what I'm thinkingFeedman and Shock Therapy Thank this.
-
Well then if my sig pic tomorrow has the straight pipes bent at a 45 degree angle I will have made your day.Feedman, KillingTime and Shock Therapy Thank this.
-
I thought computers were always right?
-
Lat/Long 44.110284 -73.436005
its 12’ 7”. It is on Rt 22/9N about 5 miles north of Port Henry, NY
rank Thanks this. -
He should pass with stacks unbent. 13-10 will fit. Use the NYDOT OS/OW tool to see what will actually fit anywhere in NY. Go to this link and find the "Launch Pre-screening tool" link in the sidebar to the right. Find the bridge or enter a route with your dimensions. Easy peasy.
xsetra, Mark Kling, rank and 1 other person Thank this. -
I measured the clearance at 14-7. Sorry @KillingTime no bent pipes
KillingTime Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 2 of 3