Vibration at low end torque

if no play in out put shaft than it is fine

 

I would check and make sure a weight didn’t get accidentally knocked off the drive line during the carrier replacement

 

doesnt make sense in his post at all though. its not driveline speed related at all. He says its rpm related. Only thing rpm related would be motor balance. Better check the balancer. If its throwing that much vibration where you can feel it, good by crank and good by motor

 

I was just going off more the “didn’t have vibration before I replaced the carrier” comment

 

Your driveline yolks have to be lined up when you put it back together you may have got it off just a little bit and that will make your driveline vibrate !!

 

Install the old carrier bearing if you still have it and see what happens.

 

Remove driveshaft and turn it half way around and re install. They should always be marked and Re-installed the same way. It can only go 2 ways.

 

Also you probably know, new straps and bolts, and torque proper. I learned the hard way broke bolt off in yoke, had to replace it. Made Me a believer. Lol