Plywood Load

Nice job. Kept the straps over the dunage nicely. Sometimes a 2x4 at the very front and very back will prevent sliding from inside the bundles. A slight bend, but don’t break

 

Up top at the plywood edges keep a strip of Two by fours tied together by short straps at either end long enough to cover three of straps over each 8 foot bundle up there. If you lay one 2x4 on top of the plywood and allowed the other 2x4 attached to it by small strips of old strap material to hang down, you can go ahead and cover those 8 foot bundles all day long without fear of cutting strap as you have it there now or chopping wood, biting into them.

It's not a bad bunch you got there. You will get better.

Another thought would be plastic corner keepers, throw one under each corner. Keep a few extra in your box.

 

The 2 things that I can see that I personally would do differently is...

Use a pocket winches or ratchet on the first strap... Going over the drive tire like that can cause problems, especially with such a heavy load if you have to make a tight turn on uneven ground or something that can dig into your rubber...

Then I would alternate straps so its pulling from both side... So wench some on drivers side and some on passenger side...

 

I like how you used that ratchet near the trailer axle... I'm wondering how did you get it rolled up around the handle the way you did, then bungeed it? I like that.

 

You have to tarp it too......?