Cascadia 2012
Discussion in 'Freightliner Forum' started by MackRookie, Aug 6, 2019.
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
-
cab 33 spn 522006 fault 5 means :
A/C Compress or clutch -Current below normal, or open circuit / conn X19, pin 6 / No load is connected
Possible Causes
1. The wiring harness to the connected load is open
2. The connected load is not functioning properly
------------
1. Check the wiring harness to the connected load
2. Check the load
------------
1. Battery voltage is greater than 9V and smaller than 16V
2. A/C compressor clutch is switched from active to inactive
most likely a/c clutch is gone. new Denso A/C compressor may be needed. If you know how to use multimeter check to see there is resistance on coil ends. separate a/c clutch is not available at dealers for Denso compressors.Last edited: Aug 6, 2019
Opus Thanks this. -
I did the ac reset. The code went away but I still have warm air coming from the ac -
Then you're out of freon or your compressor is shot. Probably 'A', and you have a leak
-
do you know how to measure resistance of circuit ?
-
No I dont. Maybe my best bet is to take it in for ac service
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.