2022 peterbilt x15 codes

Have a 2022 peterbilt x15
Code 132 accelerator pedal position sensor 1 voltage shorted or low.
Code 1241 accelerator pedal sensor 2 shorted or low
Code 2222 fuel level sensor circuit voltage above normal or shorted high.
1.I verified wiring from pedal to ecm are good.
2.i have 5v reference on pedal
3. The wiring diagram for the fuel level sensor shows a 3 wire plug, the only plug on the tanks Is a 2 wire?
4. On the radio it is showing soot level full parked regen needed? In cummins insite it shows soot level normal, tried to start a regen but it fails, also the dic shows shut down engine.
5. There is a code (using jpro only) for j1939 for abs.
Driver said all this happened at the exact same time all the lights and no pedal?
Any ideas where to start or any help?

 

Looking at the wiring diagram the pedal sensors wires directly to the ecm plus a few other sensors on same wires like the 5v. Which all those work..
I checked continuity of those wires straight to the ecm.
I unplugged the pedal sensor with no change in the codes

 

In insite when clicking on the code it does pull up a diag for the code however there ant any diagrams or connector views with pin outs. Is that normal or is that additional info a paid service?

 

Can someone help with the wiring schematic for this truck?
2022 peter 389
X14.
Also what is the best option for wiring diagrams and fault code help?