Slight bends in pushrods

98 w900 n14 cummins

Doing an overhaul and while inspecting everything I went and checked the pushrod.
All of the valve pushrod are fine but all the injector pushrod have a very slight bend in them. A few only have enough space to slide a piece of paper or 2 under it.

Are they okay to run or should I replace them? Tried to get a few decent pics

 

So when I roll them its a very very little wobble. Replace them?

 

I dont have a problem replacing, just sucks because ill have to wait another week till they arrive lol

 

Will do, thank you!

 

BTW, idk if you ever saw my other post. I had cylinder 6 catastrophically fail. Cummins and kenworth are speculating a failed injector possibly. But I found this broke. Piece in my oil pan and Noone seems to know what it is. About 1x1" cast. Any thoughts?