starter wires

Discussion in 'Freightliner Forum' started by woodboys, Mar 20, 2015.

  1. woodboys

    woodboys Bobtail Member

    3
    0
    Sep 26, 2010
    pineville, missouri
    0
    I pulled the starter wires off my starter that are part of the chassis wiring harness from the ECM to the dash and when I reconnected them the truck doesn't start now. It turns over fine just doesn't hit a lick. any clues what could be the problem? It was just 2 wires that went to the double posted hot wire and a small wire that went to I believe a solenoid and then the 2 wires that goes to the solenoid on the firewall. Last time I had the starter replaced it did this and the mechanic did something that made it start but I didn't see what he did.
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. baha

    baha Road Train Member

    4,137
    2,834
    Jul 25, 2013
    ga
    0
    You can look inside batt. box for 2 fuse inside small plastic holders, then inside fuse panel at dash,the fuse that runs ecm may have poped?
     
  4. woodboys

    woodboys Bobtail Member

    3
    0
    Sep 26, 2010
    pineville, missouri
    0
    Checked them all and all are ok.
     
  5. baha

    baha Road Train Member

    4,137
    2,834
    Jul 25, 2013
    ga
    0
    Look carefull for a small wire not put back on starter on power side of tem. on starter sol. what type truck do you have?
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.