Picked up my new 2007 9400 with cummins isk 10speed. MAN she rides good!! problem is i notice the right turn signal indicator does not work but the Signals outside do just not the dash part. IS this just a buble to unplug and replug?(ANSWERED)
Im looking for a 2007 international 4300 operators manual But cant find one its being up a Service manual BUT only for circlets anyone know where i can find one? This is my Dash look a like and i got no clue what some of the Buttons do.
9400 i
Discussion in 'International Forum' started by TruckerPete1990, Apr 25, 2015.
Page 1 of 3
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
my 07 is the same way. you have to replace the whole thing. which Is both turn sing. an high beam indicator . you have to buy it from a dealer or salvage . the dealer told me its $400.00 for it . I have lived with out it for 2 years now i'am not paying $400 for it
TruckerPete1990 Thanks this. -
any clue where to get the user manuels? its only showing me a circet one and i have 3 swtiches that i dont got a clue for. one is DIAG one says DRAG and other is not marked just on and off.
I've been researching online looking for a 2007 international 4300 operators manual. Anyone know where i could get one?Last edited: Apr 25, 2015
-
I can't get a 2007 for some reason, I do have a 2006. Your truck was probably build in 2006 anyway. As far as the turn indicator for the 9400, just remove the center cluster panel. You will see the light sockets for the turn and high beam indicators. The socket just twists a half turn and pops out. There is small bulb in there you can replace.
Attached Files:
TruckerPete1990 Thanks this. -
-
I took mine out thinking I could just replace the bulb . but mine is a little rectangle plastic peace that is held on to the panel with two screws an the wires plug in to it. there is no access to the lights . my truck was mfg in 2006
-
truckerpete your dash set up looks just like mine except I have the white gauge package.
-
I have seen some dash clusters that have no bulbs, but soldered in micro LED's. These are not serviceable unfortunately.
-
I found another one today, try this;
View attachment 2007 4300.pdf
As for the switch, remove the switch panel and check to see if there is tag on the connector at the back of the switch to label what it is.TruckerPete1990 and double yellow Thank this. -
I am not a owner nor a technician but usually those DIAG switches stand for Diagnostic.. Yours doesn't have a screen but most have a screen that if you press that switch.. It usually has fuel milage, trouble codes and the such. At least, that's how it usually works in MY experience. Good luck, none the less!
TruckerPete1990 Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 3