I removed the four batteries from my '84 Kenworth k-100 COE 400cat and lost the wiring diagram and now I am stuck.
Need help with wiring batteries for my '84 Kenworth
Discussion in 'Kenworth Forum' started by Mauldoon, Sep 14, 2014.
Page 1 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
If it is a 12vdc system,, +to+, - to neg to frame...
.... Philip -
I do know that part, but mine is 12v and 24v start and I have a P/S switch. The main cables are still there, but I need the grouping on the 24v bunch and which inner set and which outer sets to put together. I was hoping to find a photo or image of a diagram, but I haven't had any luck searching online.
-
link to a generic series parallel switch schematic
http://www.texasindustrialelectric.com/relays_1119845.asp -
Hi Mauldoon, try this. https://www.survivalmonkey.com/thre...ams-6-volt-12-volt-series-and-parallel.37039/
-
Thank you to all three. All of this information will help fill in the gaps. The last two posts with images greatly explained what I needed. If there are any other things to come up, as I am going to apply this new found information to the test some time this week, I may be back on with more questions. Thank you all again for the quick and helpful responses.
-
You're welcome. Just so you know, no guarantees if everything goes KA-BLOOEY.
-
next take a picture with the cell phone before ya move anything and also mark em.
-
I know it's probably too late but next time take a picture before you disconnect anything. Also, when I replace my batteries the wires are so stiff and tie wrapped together they can't go anywhere else except where they are suppose to.
-
Fourteen years ago I didn't think of taking pictures but thank you for all the help.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 2