Original ECM could not even be powered up outside of truck. the insulation between block and ecm corroded the aluminum housing of ECM and water...
I had to replace the ECM on my 97 3406E in a 97 FLD120, it starts, idles haven't driven it. The gauge readings are off. Dash gauge oil pressure...
Hello, I have a 1997 3406E all factory stock 6TS 40 pin in a FLD120 it is not starting and has "No Data Link Communications" on the dash...
Remove the front drive axle and leave plate and rear position alone?? Thinking about it bigger is always better,,, in most cases... thanks for...
So I have been looking around the a 9.5 through 11 L range single screw road tractor. Not much out there except for former "Roadway" equipment....
Hello, So I need a another truck again to pull my 48' Kentucky moving van trailer 34k total all the time. I may go look at a 2001 International...
Coming back into GA from SC on I85, crossing lake Hartwell I look back on GA side north bound and see a new pole with 2 cameras on it and a wind...
I was going to mount this valve to the rear drivers side, get out walk back pull move truck push it back in. [ATTACH]
yes all four rear bags.
The fuel return line comes from back of the head to filter base? If it does add a section of line to raise it up above the fuel rail level in head...
On a 97 FLD 120 twin screw air bag, is there a simple way to add an air bag dump valve? A mechanical setup would be perfect even if the lever is...
Originally it had no filter there, then I replaced the short cap with CAT branded filters and made sure the seal always came off when switching it.
I use a Cat 1r 749 on the spin on base it popped the base gasket out while idling approx 60psi, this is with a new bypass check valve. I have...
How long is a while? A bit of humor I asked the truck parts counter guy if he ever has done it him self or heard of using trailer brite to...
Nash Heavy Duty Truck Parts Athens Ga $10 for one gallon. [ATTACH]
Dealer said buy the whole tank strap, don't need the whole strap. thanks,,,,
See the pic circled in red for a 97 FLD120, anyone know were I can acquire one? used will work near Athens-Atlanta Georgia?
You can change the fittings, however what has built up behind them in the hole may have crusted over use a scribe to probe the hole before...
Ok got it, I purchased a dozen of the 86651xe, was a Carquest going to Advance store closing sale. Was a good deal... thanks for help all....
Davco has a Carquest 86651xe allegedly made by Wix (33651XE) 5 micron Secondary is a Cat 1R-0749 2 Micron is what I saw published for this...