Hey everyone. I am in need of help. I have a 2012 Coronado that will not start.I washed it the other day and went to start it. Nothing. the boss and I managed to pull start it and get it to our shop. now it wont even pull start. The truck gives networking error codes and wont even try to start. when I turn the key I hear a relay click and that is it. I tried starting the truck by shorting the starter and it turns the engine but that is it. there are 2 network codes on the dash I have to pull them and Will post them here as well. any ideas anyone?
2012 Coronado Wont Start.
Discussion in 'Freightliner Forum' started by Freightshaker15900, May 31, 2015.
Page 1 of 2
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
j1939 datalink maybe shorted to ground ...
Last edited by a moderator: Jun 1, 2015
Reason for edit: No skirting the profanity filter -
Ok its all j1939 codes. Stupid computers. Have you had this problem with any fix? Any clue where i can find the short or a wiring diagram? Thanks
-
-
Eng 2 001 Spn000639 j1939 network 07
Engine 000 Spn000639 j1939 network 07
Eec 061 spn000639 j1939 network 7 -
you said you washed the truck. did you put pressure water on motor's ecm or nearby ? I think communication is lost between motors ecm (mcm) and aftertreatment's modul (acm) . now check the connectors on mcm and acm. acm is located behind of left front wheel's splash guard.
-
He used the auto wash. We had the def delete done on it a few months ago and the acm is supposed to be disabled
-
that truck has collision warning system installed ?
-
I do not think it has that. its more of a base model
-
j1939 datalink test must be done by using diagnosticlink 8. that software will show you where is the fault. now check one more place for shortened/grounded wires. behind the sleeper, that cable for qualcom antenna. that cable has j1939 wires.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 2