noob here...
2000 379 stock 475 6nz
Simple Q.... Looking for Simple answer HAHA
Going down the road i have a vibration in the floor board around gas pedal.
let off and coast it goes away get back on it it comes back.
trucks at cat now. No failed injector codes. injectors were replaced by cat in jan 2010.
CAT IN-FRAME done 3 yrs ago (just out of warranty except injectors just put in jan 2010)
any help would be greatly appreciated.
TIA
Peterbilt / 6NZ Vibration
Discussion in 'Trucks [ Eighteen Wheelers ]' started by jaysolomon, Sep 22, 2010.
Page 1 of 5
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Driveline vibration... look for bad u-jonts/tight u-joints, bad driveshaft support bearing, bent shaft, worn yoke....
-
My thinking is if it is drive-line then wouldn't it vibrate all the time even if i let off the pedal and coast?
Thanks -
How about engine mounts?
-
-
get your suspension ride height checked, petes were notorious for making all kinds of weird sounds/vibrations if the ride height was not correct.
Oxbow Thanks this. -
-
-
do you have balancers on steer's? if so, could be the balancers. was thinking if you have centramatics where there are steel balls in tube, this may cause slight vibration. just a thought.
-
How do you know if your carrier bearing is bad?
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 5