You might get ya Package today if Amazon doesn't Park Upside Down in the Bushes
What if it Snows?
Discussion in 'Questions From New Drivers' started by Dave_in_AZ, Mar 19, 2018.
Page 10192 of 23529
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
How long have you been driving for TFIWS?
DrFlush, Opus, DeereRunner97 and 15 others Thank this. -
-
-
-
InTooDeep, kemosabi49, Dale thompson and 11 others Thank this.
-
Same way. Torque to 200lbs. while turning, to seat the bearings. Back off 1 full turn. Torque to 50 lbs. Back off 1/2 turn. In my case in the steer, the specs say back off 1/3 of a turn. Final torque Lock nut to 250-300. I chose 280. I had some wear markings on my bearings. I should have took a picture. The ends were good. They’re not running loose. The front bearing had wear on 1/3 of the rollers, right in the middle on each. The rear bearing had less signs of wear, barely noticeable, just past the center, towards the larger part of the cage. Maybe signs of being too tight. I measured the threads years ago. 12 per inch. I’m going to keep an eye on both. Might need to start backing them off between 1/3“and 1/2”. Or maybe do the final torque to 250, instead of 280. Maybe my Uncle and I measured the threads wrong. I don’t think so, we used a gauge.DeereRunner97, Dale thompson, Boondock and 10 others Thank this.
-
-
Don’t show off your fancy shirts and lean figure. Thats just in bad taste. Be more humble
Opus, DeereRunner97, InTooDeep and 14 others Thank this. -
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 10192 of 23529