I have a 1992 International Cabover with an N14 in it, tried several truck mechanics and all don’t have a plug to fit what’s on the truck from the ECM and say they haven’t seen the plug before, anyone know what to do about this
N14 ECM Plug
Discussion in 'Heavy Duty Diesel Truck Mechanics Forum' started by awarthogfan, Jun 22, 2022.
Page 1 of 3
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
92 should be OBD II. A pic would help
Coffey Thanks this. -
spsauerland Thanks this.
-
-
-
Big Road Skateboard Thanks this.
-
This is the plug inside the cab
Both sides of plug beside ECM -
It was pretty simple actually. Had to figure out which wires to hook up. Looked at things on line like 9 pin, N14 wiring etc.
Maybe only takes 4. Battery power. Power with key. Ground. Then one or two to ecm. You will be in business.spsauerland Thanks this. -
The on engine data connector is located between the fuel pump & the block.
Near the mounting flange. It's a 2 wire weatherpackspsauerland Thanks this. -
Attached Files:
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 3