What if it Snows?
Discussion in 'Questions From New Drivers' started by Dave_in_AZ, Mar 19, 2018.
Page 13777 of 23214
-
Cowboyrich, The_vett, IH9300SBA and 8 others Thank this.
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
stuckinthemud, austinmike, IH9300SBA and 12 others Thank this.
-
Honest question... You figure that idler out, or had you seen some similarity ops before ? Dirt simple, when you see it, but I had not even considered that way.
Again, unique solution.stuckinthemud, IH9300SBA, DeereRunner97 and 7 others Thank this. -
We were woefully unprepared in the long pants / sweat shirts department for freeze to death and DIE conditions, and ours are trashed.
I was told to spend $50 of our DETENTION ( Always moist and delicious ) money, and do a load of laundry.stuckinthemud, austinmike, IH9300SBA and 10 others Thank this. -
austinmike, IH9300SBA, Feedman and 5 others Thank this.
-
@JolliRoger this is my favorite part of the whole machine. 100% my own design. Its the mechanism used to tension the drive belts on the motor.
Those long threaded shafts move the entire platform the the motor is mounted on up and down the main frame to tension the drive belts, the 2 bolts on each side ride in slots in the platform to keep it straight and in alignment with the frame.
That is a stainless steel shaft with ACME threads, with mild steel ACME thread nuts on either side of a length of heavy wall mild steel pipe. By using a mild steel nut on a stainless thread it won't rust the nuts to the thread and the nuts and thread wont gall to each other. Same principle applys to the stainless thread through the mild steel pipe. Also the threads themselves are beefy enough that even with a bunch of crap jammed into them they are nearly impossible to strip out at the speed of a wrench.
This machine hadn't had those nuts moved for at least 2 or three years... And even though I had to torch off all the regular bolts, thise freed up with only a wrench (no heat needed) and with a little lubricant I had all 4 of them spinning by hand in less than 5 mins.stuckinthemud, IH9300SBA, Feedman and 11 others Thank this. -
stuckinthemud, austinmike, DeereRunner97 and 7 others Thank this.
-
The one with the fur never get cold and the ?? without freezes his ###... Just saying..stuckinthemud, IH9300SBA, DeereRunner97 and 10 others Thank this. -
You'll learn.stuckinthemud, austinmike, IH9300SBA and 10 others Thank this. -
Feedman, DeereRunner97, D.Tibbitt and 7 others Thank this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 13777 of 23214