Roll off - a general question

I drive a roll off for a scrap steel company now. Roll off trucks are a tricky breed. All the same stuff posted above, customers can be crazy and have cans loaded way too heavy or way too high. Have to tarp my loads by hand, so very careful to not fall on loads. I've also driven super 18 (16 wheel truck with "strong arm" on rear) dump trucks hauling asphalt. A good spraying of diesel in the bed before loading under silo makes unloading much easier. Banging the gate wont hurt a thing, except if coming out if the paver and slowing down the line. All paving jobs I've been on had a "clean out" area, could bang gate there and spray down apron and gate there.

 

Really, you don't need much diesel to keep a load of hot mix from sticking. I used a gallon garden sprayer, and usually only used about 1/8 gallon per load. I think the reason diesel has been prohibited is because guys would spray so much in the body it would be running out the back as they were being loaded.

 

Most hot rock plants I've been to have a cat walk set up just before the silo where you can climb up on it and they have a soap gun so you can spray your bed down with soap. The soap works great and isn't a pollutant like diesel is.

 

The word good was used the sense of quality and not quantity. Those plants that have the cat walks are nice, I've even seen few that have an automatic sprayer you drive under. The soap from all those is good stuff. Rather expensive but I actually used cooking oil in my one gallon sprayer.

 

I've been around dumps for quite a while. Banging your gate once is fine but excessive banging with start cracking the welds on the latches/dog ears or whatever you want to call them.