No way to really put a trip on hold. You can add the truck stop as a Via or turn the recalculation to Manual (Preferences/General/route). This will basically keep the same routing when you pull off to an unplanned stop in your route. Note - turning the unit off and on again, it may pick a different route that the one you were on.
You can normally build a trip and if you add via points, go to Choose destination/Multi-Stop trips/Current trip and do a Save As and save it to another folder. Then when you turn the unit off/on, go back to the same screen and pick your trip folder. Do a Start Trip from this folder and then modify the current trip folder for the locations you do not need anymore.
Thanks,
Mark
Suppport Thread for the TND 500, TND 700 or future Rand McNally products.
Discussion in 'Trucking Electronics, Gadgets and Software Forum' started by Mark Kling, Apr 16, 2010.
- Thread Status:
- Not open for further replies.
Page 734 of 756
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
stuck -
Do you have LTM's?
Thanks,
Mark -
Question though, LTM's ? Not really computer literate.
stuck -
-
stuckinthemud Thanks this.
-
thanks
stuck -
Dock software request. This is post #7 , maybe I can send a PM now
Thanks
stuck -
I will send you the installer, but suggest you contact your service provider and see what the cost is for going over your limit. Usually if you have a Data Plan they will charge your $x per GB over.
Thanks,
Mark -
stuck
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 734 of 756
- Thread Status:
- Not open for further replies.