OK, thanks for the information. I'll watch this thread to see what else is done to bypass problem areas.
Yeah Mark, I did notice an exit that was not correct on the northwest portion of 485. May I ask how often the updates are released?
Thanks
Support Thread for the TND 500, TND 700 or future Rand McNally products. (part two)
Discussion in 'Trucking Electronics, Gadgets and Software Forum' started by Mark Kling, Jul 7, 2014.
- Thread Status:
- Not open for further replies.
Page 325 of 470
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
-
One other option is to use GoogleMaps, zoom in to about exit 4, but leaving the "point" on the freeway. Right click, what's here, and get the Lat/Long. Use the Lat/Long as your Via point since this is an actual point on the freeway and not on an exit.
You can also scroll on the screen to a part of 485 that you want to add as a Via, place the "x" on the road, zoom in all the way to make sure you are on the right part of the freeway, at the bottom it should show "add as via".
Thanks,
Mark -
Thanks,
Markarchangelic peon Thanks this. -
-
Thanks,
Mark -
Mark Kling Thanks this.
-
Thanks,
Mark -
Believe if you turn off "Fast Recalculate" it will do a full recalculation every time you venture off route instead of the 3 nags then recalculation.
Might cut down on the daily nag count. -
Thanks,
Mark
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 325 of 470
- Thread Status:
- Not open for further replies.