2012 volvo vibration

Discussion in 'Volvo Forum' started by mladen86, Aug 24, 2014.

  1. Achogeo5

    Achogeo5 Bobtail Member

    7
    1
    Feb 8, 2016
    0
    When I turn engine on , yes everything shakes until it gets little bit warmer , It has 464431 miles , yes hard pulls do the rpm flutter up and down ((
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Volvoman78

    Volvoman78 Bobtail Member

    1
    0
    Mar 3, 2016
    0
    Has replacing the injectors with new stainless steel cups solved your problem?
     
  4. mladen86

    mladen86 Medium Load Member

    303
    269
    Aug 23, 2012
    Chicago,il
    0
    Yes,truck was ok after new injectors and cups.
     
  5. Flynryan345

    Flynryan345 Bobtail Member

    11
    2
    Aug 18, 2017
    0
    I have a Ken worth today was headed to Nashville and it started doing same thing yours was doing but when truck was sitting there at a idle it started to rev up I was afraid it was running away I ran to it but then it went back to normal idle runs fine till you have a load on motor then it shacks, could it be injectors or do I have another problem ?
     
  6. glmi1

    glmi1 Bobtail Member

    6
    1
    May 15, 2014
    0
    I also have the shaking problem on a 2012 D11 I-Shift. It happens while in 12th gear around 1100rpm. RPM will also go jump up and down by about 75rpm as this is happening. It gets especially bad while on an incline. Goes away as soon as I let off throttle or transmission downshifts to 11th gear.

    Has codes for voltage/short on cylinders 1 and 3.
    EGR mass flow rate
    Turbo Boost Pressure

    I've heard that a bad engine wiring harness causes this problem. Has anyone had success replacing only the harness?
     
  7. Boromak18

    Boromak18 Light Load Member

    62
    11
    Jan 11, 2018
    0
    Did you fix the problem Ihave the sasme issue on d13 vnl 670 2012
     
  8. glmi1

    glmi1 Bobtail Member

    6
    1
    May 15, 2014
    0
    Yes. I first replaced the engine harness but the problem continued. A week ago I replaced all 6 injectors and cups with the updated stainless steel cups and the engine is running smooth-- no shaking, no misfiring and my MPG is back up. All the fault codes are gone as well.
     
    Boromak18 Thanks this.
  9. Premiere14

    Premiere14 Bobtail Member

    20
    0
    Jan 3, 2018
    0
    I haven' been following this thread so it may have been said already. Need to check the carrier bearing. Sometimes they are very hard to see. Also a two man job to be a little safer. The best way is to jack the truck up and put on jack stands. One person under truck the other in the seat. Put in 5 or sixth gear and let idle.
     
  10. Newto Trucking

    Newto Trucking Medium Load Member

    359
    225
    Dec 26, 2013
    NE Illinois
    0
    what dealer did you do a dyno at??? was it a volvo dealer???
     
  11. mladen86

    mladen86 Medium Load Member

    303
    269
    Aug 23, 2012
    Chicago,il
    0
    Yes,volvo in Alsip,IL.
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.